Important:
Always switch off and remove the
plug from the electricity supply before cleaning
the condenser.
To maintain the efficiency of the dryer regularly
check that the condenser is clean.
CONDENSER
OPERATION
1.
Open the door and load the drum with
laundry. Ensure that garments do not hinder
closure of the door.
2.
Gently close the door pushing it slowly until
you hear the door 'click' shut.
3.
Turn the Programme Selector dial to selec
t
the required drying programme (see
Program
-
me Guide).
4.
If drying synthetics, acrylics or delicate items,
press the
Delicates
button to
reduce the heat
level.
The light next to the push button will light
up
when the machine is in low heat setting.
To
deselect in the first few minutes of the
programme, press the
Delicates
button, after
this time reset the machine to
change the
setting.
5.
Press the Start/Pause button. The dryer will
start automatically and the DRY indicator
will be
continuously lit.
6.
If the door is opened during the programme
to
check the laundry, it is necessary to press
Start/Pause to recommence drying after the
door has been closed.
7.
When the cycle is nearing completion the
machine will enter the cool down phase, the
clothes will be tumbled in cool air allowing
the
load to cool down.
8.
When the programme is complete the END
indicator will light.
9.
Following the completion of the cycle the
drum will rotate intermittently to minimize
creasing. This will continue until the
machine is
switched OFF or the door is
Opened.
To Remove the Condenser
1.
Remove
the kickplate
.
2.
Turn the two locking levers
anti-clockwise
and pull out
the condenser.
3.
Pull out the condenser
unit.
4.
Gently remove any dust or
fluff with a
cloth, then wash
the unit by holding it under a
running tap turning it so that
water flows between the
plates, to remove any dust or
fluff.
7.
Refit the kickplate.
5.Check the gasket position
after cleaning.Fit the gasket
in to the groove if it is
misaligned.
6.
Refit
the condenser
ensuring
it is in the
correct way (as
indicated by the arrow) and
pushed firmly into place. Lock
the two levers by turning them
c l o c k w i s e . B e s u r e t h a t
condenser unit fixed to the
basement tightly.
EN 12
