must be conformed to the current norms of the
installation country. Connection to the power
source can also be made by placing an omnipolar
breaker, with contact separation compliant to the
requirements for overvoltage category III,
between the appliance and the power source
that can bear the maximum connected load and
that is in line with current legislation. The yellow-
green earth cable should not be interrupted by
the breaker. The socket or omnipolar breaker
used for the connection should be easily
accessible when the appliance is installed.
• The disconnection may be achieved by having
the plug accessible or by incorporating a switch in
the fixed wiring in accordance with the wiring
rules.
• lf the power cable is damaged, it should be
substituted with a cable or special bundle
available from the manufacturer or by contacting
the customer service department. The type of
power cable must be H05V2V2-F. This operation
should be carried out by a suitably qualified
professional. The earth conductor (yellow-green)
must be approximately 10 mm longer than the
other conductors. For any repairs, refer only to
the Customer Care Department and request the
use of original spare parts.
• Failure to comply with the above can
compromise the safety of the appliance and
invalidate the guarantee.
• Any excess of spilled material should be
removed before cleaning.
• A long power supply failure during an occurring
cooking phase may cause a malfunction of the
monitor. ln this case contact customer service.
• The appliance must not be installed behind a
decorative door in order to avoid overheating.
• When you place the shelf inside, make sure that
the stop is directed upwards and in the back of
the cavity. The shelf must be inserted completely
into the cavity.
• WARNING: Do not line the oven walls with
aluminium foil or single-use protection available
from stores. Aluminium foil or any other
protection, in direct contact with the hot enamel,
risk melting and deteriorating the enamel of the
insides.
EN 03
• WARNING: Never remove the oven door seal.
• CAUTION: Do not refill the cavity bottom with
water during cooking or when the oven is hot.
• No additional operation/setting is required in
order to operate the appliance at the rated
frequencies.
• .WARNING: before initiating the automatic
cleaning cycle:
- Clean the oven door;
- Remove large or coarse food residues from the
inside of the oven using a damp sponge. Do not
use detergents;
- Remove all accessories and the sliding rack kit
(where present); -Do not place tea towels.
• ln ovens with meat probe it is necessary, before
making the cleaning cycle, close the hole with the
nut provided. Always close the hole with the nut
when the meat probe is not used.
• During the pyrolytic cleaning process, surfaces
can heat up more than usual, children must
therefore be kept at a safe distance.
•
Oven trays and grids are not suitable for direct
contact with food. Please use suitable cookware
or baking paper.
