EN
Troubleshooting
Many occuring problems could be solved by yourself without specific expertise. In
case of a problem please check all shown possibilities and follow below instructions
before you contact an after sales service. See CUSTOMER SERVICE.
Problem
Possible Cause
Possible Solution
The compressor
does not work.
•
Mains plug is not connect
-
ed in the mains socket.
•
The appliance is in the
defrosting cycle
•
Connect the mains plug.
• This is normal for an automatic
defrosting
The appliance
runs frequently or
runs for a too long
period of time.
• The indoor or outdoor
temperature is too high.
•
The appliance has been off
power for a period of time.
•
A door of the appliance is
not tightly closed.
•
The door has been opened
too frequently or for too
long.
•
The temperature setting
for the freezer compart
-
ment is too low.
•
The door gasket is dirty,
worn, cracked or mis
-
matched.
•
The required air circulation
is not guaranteed.
•
In this case, it is normal for the
appliance to run longer.
•
Normally, it takes 8 to 12 hours
for the appliance to cool down
completely.
• Close the door/drawer and
ensure the appliance is located
on a level ground and there is
no food or container jarring the
door.
•
Do not open the door/drawer
too frequently.
•
Set the temperature higher
until a satisfactory refrigerator
temperature is obtained. It
takes 24 hours for the refriger
-
ator temperature to become
stable.
• Clean the door/drawer gasket
or replace them by the cus
-
tomer service.
•
Ensure adequate ventilation.
The inside of the
refrigerator is dirty
and/or smells.
• The inside of the refrigera-
tor needs cleaning.
• Food of strong odour is
stored in the refrigerator.
• Clean the inside of the re-
frig-erator.
•
Wrap the food thoroughly..
WARNING!
▶
Before maintenance, deactivate the appliance and disconnect the mains plug
from the mains socket.
▶
Electrical equipment should be serviced only by qualified electrical experts, be
-
cause improper repairs can cause considerable consequential damages.
▶
A damaged supply should only be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
23
Summary of Contents for CNCQ2T620EX
Page 35: ......
