13
ENGLISH
Trouble shooting
Should your dryer operate incorrectly,
check the following points before calling
for a service engineer.
Drying time is too long/clothes are not
dry enough:
●
Have you selected the correct drying
time/programme? Go to page 9.
●
Were the clothes too wet? Were the
clothes thoroughly wrung or spin-
dried?
●
Does the filter need cleaning? Go to
page 7.
●
Does the condenser need cleaning? Go
to page 8.
●
Is the dryer overloaded? Go to page 6.
●
Are the inlets, outlets and base of the
dryer free from obstructions?
●
Has the
button been selected from a
previous cycle? Go to page 10.
The dryer does not operate:
●
Is there a working electricity supply to
the dryer? Check using another
appliance such as a table lamp.
●
Is the plug properly connected to the
mains supply?
●
Is there a power failure?
●
Has the fuse blown?
●
Is the door fully closed? Go to page 11.
●
Is the dryer switched on, both at the
mains supply and at the machine? Go to
page 10.
●
Has the drying time or the programme
been selected? Go to page 10.
●
Has the machine been switched on
again after opening the door? Go to
page 7.
●
Has the dryer stopped operating
because the water tray is full and needs
emptying? Go to page 8.
Filter Care Indicator on
●
Does the filter need cleaning? Go to
page 7.
Empty Water Indicator on
●
Does the water container need
emptying? Go to page 8.
If the supply cord on this appliance is
damaged, it must be replaced by a special
cord which is only available from GIAS
Service or an authorised Dealer.
Should there still be a problem with your
dryer after completing all the
recommended checks, please call GIAS
Service for advice. They may be able to
assist you over the telephone or arrange for
a suitable appointment for an engineer to
call under the terms of your guarantee.
However, a charge may be made if any of
the following applies to your machine:
●
Is found to be in working order.
●
Has not been installed in accordance
with the installation instructions.
●
Has been used incorrectly.
40001731English.fm Page 13 Monday, September 6, 2004 4:21 PM