6
Cleaning the Inside
Unplug your Wine Cooler and remove all bottles. Rinse the inside surface with plain
water and dry the chrome shelves.
WINE COOLER TROUBLESHOOTING:
LCD displays “PROBE ERROR – E”
This message is an ALARM MODE indication. The LCD displays “PROBE ERROR”
on the left and “E” in the middle when the thermostatic sensor has malfunctioned.
When this hap- pens, the Cooler first stops working for 25 minutes, then turns ON for
30 minutes and OFF for 20 minutes automatically and continuously. Contact your
authorized service facility for sensor replacement.
LCD displays “LOW TEMP”
This message is an ALARM MODE indication. The LCD displays “LOW TEMP” on
the left and the actual temperature reading in the middle. It indicates that the actual
temperature is much lower than your set temperature and that the magnet valve may
not be functioning properly and should be replaced. Contact your authorized
service facility immediately.
LCD displays “HIGH TEMP”
This message is an ALARM MODE indication. The LCD displays “HIGH TEMP”
on the left and the actual temperature reading in the middle. It indicates that the
actual temperature is much higher than your set temperature. Possible causes are:
• The door might not be fully closed.
• The refrigerant may have leaked.
• The magnet valve may not be functioning properly and should be replaced.
If you are certain that the door is not the cause of the problem, contact your
authorized service facility immediately.
GENERAL INSTRUCTION FOR WINE COOLER:
USING ATTENTION
Store wine in sealed bottles.
Do not overload the cabinet.
Do not open the door unless necessary
Do not cover shelves with aluminum foil or any other shelf material, which may prevent
air circulation.
Should the wine cooler be stored without use for long periods it is suggested, cut off
the power and careful cleaning, leave the door ajar to allow air to circulate inside the
cabinet in order to avoid possible formations of condensation, moldy or odors.
The appliances are designed with LED light, if LED light damage, pls contact with
after-sale service to replace it.