EN
111
FAULTS
CAUSE
SOLUTION
5. Spray arms are
not heard to
rotate
Excessive amount of detergent
Reduce amount of detergent Use
suitable detergent
Item prevents arms from rotating
Check
Filtering plate and filter very dirty
Clean filtering plate and filter
6. On electronic
appliances
without a
display: one or
more indicator
lights flashing
quickly
Water supply tap turned off
Switch off the appliance. Turn on
the tap. Re-set the cycle.
7. Dishes only
partially washed
See point 5
Check
Bottom of saucepans have not
been washed well
Burnt on food remains must be
soaked before putting pans in
dishwasher
Edge of saucepans have not
been washed well
Reposition saucepans
Spray arms are partially blocked
Remove spray arms by unscrewing
ring nuts clockwise and wash under
running water
The dishes have not been
loaded properly
Do not place the dishes too close
together
The end of the drain pipe is
immersed in water
The end of the drain pipe must not
come into contact with the outflow
water
An incorrect amount of
detergent has been measured
out, or the detergent is old and
hard
Increase the measure according to
how dirty the dishes are, or change
detergent
The cap of the salt container is
not closed properly
Choose a more vigorous
programme
The wash programme is not
thorough enough
Tighten it properly
8. Detergent not
dispensed or
partially
dispensed
Cutlery, dishes, pans, etc., stop
the detergent dispenser from
opening
Position dishes so as not to
obstruct the dispenser
9. Presence of
white spots on
dishes
Mains water is too hard
Check salt and rinse aid level and
regulate. Should the fault persist,
contact the Technical Assistance
Centre
10. Noise during
wash
The dishes knock against one
another
Re-check loading of dishes in the
basket
The revolving arms knock
against the dishes
Re-check loading of dishes in the
basket
11. The dishes
are not
completely dry
Inadequate air flow
Leave the dishwasher door ajar at
the end of the wash program to
allow the dishes to dry naturally
Rinse aid missing
Fill the rinse aid dispenser
