6
Description of controls
Fig. 1
Door handle
A
"Door Security" indicator light
B
"Start/Pause" button
C
"Super Rapid" button (C1 508)
D
"Crease Guard" button (C1 105)
D
"Activa Rinse" button (C1 508 - C1 105)
E
"Slow Spin" button (C1 105)
F
"No Spin" button (C1 508)
F
"Delay Start" button
G
"Time To End" indicator light
L
Buttons indicator light
M
Programme selector with "OFF" position
N
Detergent drawer
P
B
C
N
A
P
G
D E F
L
M
Door handle
Press the finger-bar inside the door handle to open the door.
A
7
DOOR SECURITY indicator light
The “Door Security” indicator light is illuminated when the door is fully closed and the machine is ON.
When "Start/Pause" is pressed on the machine with the door closed the indicator will flash
momentarily and then illuminate.
If the door is not closed the indicator will continue to flash.
A special safety device prevents the door from being opened immediately after the end of the cycle.
Wait for 2 minutes after the wash cycle has finished and the “Door Security” light has gone out
before opening the door. At the end of the cycle turn the programme selector to "OFF" .
B
NOTE: When the "Start/Pause" button has been pressed,
the appliance can take few seconds before it starts
working.
START/PAUSE button
When a programme is selecting, wait for the “STOP” indicator
light to flash before pressing the "Start/Pause" button.
Press to start the selected cycle (according to the selected cycle one indicator lights will go on) .
Changing the settings after the programmes has started (PAUSE)
The programme may be paused at any time during the wash cycle by holding down the
"Start/Pause" button for about two seconds. When the machine is in the paused mode, the
indicator light "Time To End" and option buttons will flash.
To restart the programme, press the "Start/Pause" button once again.
If you wish to add or remove items during washing, wait 2 minutes until the safety device
unlocks the door.
When you have carried out the manoeuvre, close the door, press "Start/Pause" button and
the appliance will continue working where it left off.
CANCELLING THE PROGRAMME
To cancel the programme the programme selector should be rotated to the "OFF" position.
C
