Candy 496TWMB6/1-S, Manual, Page: 69 / 136

69
EN
PAUSING THE MACHINE

While a cycle is running, the machine can
be paused by simply pressing the
PLAY/PAUSE button.
 Press the
PLAY/PAUSE
button again to
resume the programme from the cycle
phase where it left off.
CANCELLING THE SET PROGRAMME
 To cancel the programme, set the
selector to the OFF position.
 Wait until the DOOR LOCKED light has
gone out before opening the door.

This button allows you to change the
temperature of the wash cycles.

It is not possible to raise the temperature
over the maximum allowed for the
programme, in order to protect the
fabrics.

If you want carry out a cold wash all the
indicators must be off.

By pressing this button, it is possible to
reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.

If the label does not indicate specific
information, it is possible to use the
maximum spin expected in the program.

To reactivate the spin cycle press the
button until you reach the spin speed you
would like to set.

It is possible to modify the spin speed
without pausing the machine.
(Available on some programmes only)
This function allows you to minimize
creases as much as possible, eliminating
the intermediate spins or reducing the
intensity of the last one.

This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to 24 hours .
DELAY START button
This option must be selected before
pressing the PLAY/PAUSE button.
If the option is not compatible with the
selected programme then the option
indicator light first flashes and then
goes off.
EASY IRON button
The machine is fitted with a special
electronic device, which prevents the
spin cycle should the load be
unbalanced. This reduces the noise
and vibration in the machine and so
prolongs the life of your machine.
An over dosing of detergent can
cause excessive foaming. If the
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the program and increase water
consumption.
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
SPIN SPEED button
TEMPERATURE SELECTION
button
For safety reasons, in some wash
cycle phases, the door can be opened
only if the level of the water is below
its lower edge and if the temperature
is less than 45°C. If these conditions
are met, wait for the DOOR LOCKED
light to switch off before opening the
door.