Step 4 - Assemble the Lids
Rotate the case so the top is right side up. Grasp the short
1-1/2”flaps (long flap running along the top) on each lid and bend inward
several times — this helps make assembly easier.
Insert the remaining 4 screw posts into the
lower holes of each of the corners of the lid.
Again, flat side of screw post toward the
inside of the box.
(see figure 13)
Figure 13
Fold the flap with the screw post into the case, then
fold the rounded end over the flap with the screw post,
align the holes and place a screw head in the holes
and tighten - again, don’t over tighten but make sure
the screws are snug
(see figure 14 and 15)
Repeat until all 4 corners
Are assembled (see figure 16)
Figure 14
Figure 15
When the lids are assembled correctly the long
outside flaps will be slightly bowed.
(see figure 16)
This is correct—it helps keep the lids closed.
Figure 16
Once the case is completely assembled you can close the lid —
you will have to work with the lid a little to get it to close due to the
nature of the material, however over time it will become easier as the
material breaks in.
