10
H. HEAD
There are three head
’s on Hullabaloo all with vacuflush toilets. Remember vacuflush toilets
use fresh water from your water tanks.
Marine heads are complicated mechanisms and the smallest of items can plug the head or
the accompanying systems. Even a match stick or a wad of hair can cause problems.
NEVER place anything in the head that has not first been consumed, except for a small
amount of MARINE grade toilet paper.
Do not place ANY foreign material into toilet including feminine products, make up
tissue, paper towels, cotton balls, baby wipes, non-marine grade toilet paper. These
items can clog or damage system requiring costly repairs.
The pumps and other related equipment for the vacuflush toilets are located in the stern
lazarette. The macerator pump and thru hull value for pumping overboard are also located
in the stern lazarette. The switch for the macerator pump is located on the DC panel in the
wheel house.
The switch should stay in the Off position unless it is being used. Valve
in lazarette must be opened BEFORE turning switch on.
Even though the vessel is equipped with macerator and overboard pumps, it is
ILLEGAL
to
pump wastewater in the US. To discharge the Waste Water Holding Tank in a
LEGAL
discharge area you need to be in Canadian waters, except in no-discharge zones. Always
check local and federal regulations before discharging.
• The switch for the macerator pump is on the fuse panel below the lower helm.
• Activate the switch and listen to the sound of the pitch.
• When the holding tank is empty the sound of the pump will change.
Never operate
macerator when the tank is empty.
Holding tank treatment should be added to the tank after it is emptied. See bottle for
instructions.
I. GALLEY
RANGE
Hullabaloo has a Force 10 propane range with oven with igniters. The main breaker is on
the DC panel. The gas switch in located on a panel over the left side of the stove.
To light, push oven knob (far right knob) in and turn desired burner knob or the oven knob
to light position. Hold in until lit and then turn to desired setting before releasing.
