Please read all of the instructions prior to installation
Candeo Zigbee Dimmer Module - C201
Installation
1.
Turn off the power.
i. To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or
circuit breaker before installation and maintenance.
ii.
Be aware that even if the circuit breaker is off, some voltage may remain in the wires — before
proceeding with the installation, be sure no voltage is present in the wiring.
2. Connect the device according to the diagrams shown below for either a 1-wire (without neutral) or 2-wire
(with neutral) system.ultiway system.
One-wire configuration
Two-wire configuration
• Single switch, Two-way
and Multiway switching
can be achieved using
push/retractive switches.
(Please note that toggle
(on/off) switches are not
supported.)
• Once connected with a
push switch, press the
switch once to switch ON/
OFF, and press and hold
it to increase or decrease
the brightness level.
Caution: If in any
doubt about how to
install the module,
please consult a
qualified electrician.
3. After successfully wiring the switch, turn the power back on.
N
L
N
L
N
L
N
L
