Candeo Rotary Zigbee Dimmer Switch - C202 / C202N
For further support please go to www.candeo.io
Advanced Zigbee configuration
1. TouchLink to a Zigbee Remote
i.
Turn on the light, press the knob 3 times with a long press on the third time (3 seconds).
ii. The light will blink 3 times and then stay continuously on to show that the device is in TouchLink
commissioning mode. This times out after 3 minutes, after which repeat this step if necessary.
iii. Bring the remote or touch panel within 10cm of the switch.
iv. Set the remote or touch panel into TouchLink commissioning mode, by following the instructions in
the corresponding remote or touch panel manual.
v. Once connected, the light will blink 10 times, and you can control your lights remotely.
•
Using directly via Touchlink (with neither device added to a Zigbee network), each device can link
with 1 remote.
• Using Touchlink when both devices are added to a Zigbee network, each device can link with max. 30
remotes.
• After Touchlink pairing, the device can be controlled by the linked remotes.
Notes:
2. Find and Bind Mode
Note: Make sure the device and remote are already added to the same Zigbee network.
i.
Turn on the light, press the knob 4 times with a long press on the fourth time (3 seconds).
ii. The light will blink 4 times and then stay continuously on to show that the device is in Find and Bind
Mode. This times out after 3 minutes, after which repeat this step if necessary.
iii.
Set the remote or touch panel (target node) into find and bind mode, and enable it to find and bind
initiator. Please refer to the corresponding remote or touch panel manual.
iv. There should now be an indication on the remote or touch panel that it has binded to the device
successfully and can now control it.
Instructions version: 2202.1
