Please read all of the instructions prior to installation
Candeo Zigbee Dimmer module - C201
Safety Warnings
•
Turn Off Mains Power before installing the device
•
Do not expose the device to moisture
•
Do not open the case of the dimmer
Installation
1.
Turn off the power.
i. To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or
circuit breaker before installation and maintenance.
ii.
Be aware that even if the circuit breaker is off, some voltage may remain in the wires — before
proceeding with the installation, be sure no voltage is present in the wiring.
iii. Take extra precautions to avoid accidentally turning the device on during installation.
2. Connect the device according to the diagrams shown below for either a 2-wire or 3-wire system.
i. Please note, if you are not using a N wire, connect the N (Cx) and Load ( ) terminal to improve the
stability of the dimming.
N
L
Min.
Reset
Indicator
Max.
Speed.
Cx
L L
230V
～
50Hz 5-250W
Tr
ailing Edge Sma
rt Dimmer
c a n d e o
C201
Min.
Reset
Indicator
Max.
Speed.
Cx
L L
230V
～
50Hz 5-250W
Tr
ailing Edge Sma
rt Dimmer
c a n d e o
C201
N
L
N
L
Min.
Reset
Indicator
Max.
Speed.
Cx
L L
230V
～
50Hz 5-250W
Tr
ailing Edge Sma
rt Dimmer
c a n d e o
C201
Min.
Reset
Indicator
Max.
Speed.
Cx
L L
230V
～
50Hz 5-250W
Tr
ailing Edge Sma
rt Dimmer
c a n d e o
C201
N
L
3. Turn the power back on.
Caution: If in any doubt about how to install the module, please consult a qualified
electrician.
Push / Retractive
switch
