Candela AlexTriVantage, Operator'S Manual

Page: 85 / 116

8501-00-1800, Revision 05 Confidential 5-3
Candela Corporation AlexTriVantage Laser System
Fault Messages
A fault message typically occurs due to a system malfunction. Sometimes clearing the fault
and retrying the previous operation can be successfully accomplished without further faults
occurring. If a fault message persists, call Candela Technical Support and report the Fault
Number. Fault processing automatically places the system into the Standby state.
The following conditions occur outside of normal system operation. When the system enters
a fault condition, it beeps and displays a fault message (see page 5-3 for an example of a
fault message).
Figure 5-1: Example of Fault Message
Table 5-2 lists the possible fault messages and possible solutions to resolve them. These
solutions do not replace the instructions or procedures given in this guide. Review all
instructions and procedures in this guide before performing the following troubleshooting
solutions.