Candela AlexTriVantage, Operator'S Manual

Page: 53 / 116

8501-00-1800, Revision 05 Confidential 2-23
Candela Corporation AlexTriVantage Laser System
Calibration Button
The Calibration button is used to place the system into the Ready state and to begin the
calibration process (see
Figure 2-18 ).
Figure 2-18: Calibration Button
The Handpiece must be inserted into the Calibration Port before calibration can take place. If
the Handpiece is not installed, a dialog appears prompting you to install it. If the Handpiece is
in the Calibration Port, the system prompts you to press and hold the Footswitch. The action
starts the calibration.
When you enter Ready state, the System Indicator displays the Ready status (green) and the
Ready Indicators above the Keylock Switch and on the Delivery System Cable are
illuminated.
You must perform a calibration when you start the system and anytime you change the
Handpiece. If you select the Calibration button, and the system was already calibrated, the
system stays in the Standby state, rather than entering the Ready state. If you select the
Calibration button and the system has not been calibrated, you are prompted to start the
calibration. You are also prompted to calibrate the system if you change the Handpiece.
Standby/Ready Button and Status Area
This control is located in the upper, right corner of the screen. It allows you to toggle between
the Ready and Standby state and it also shows the status of the system.
Standby/Ready Button
Table 2-2 describes the function of the Standby/Ready button. The Standby/Ready button
toggles between the Standby state and the Ready state. This area is also used to show the
status of the system (see
“Status Area” on page 2-25 ).
Caution: Do not enter the Ready state without a fiber installed and without having
the proper protective eyewear on.