CandCNC DCP-01, Setup And Installation Manual, Page: 3 / 54

Programming Headers
(For factory use only)
DB9 Socket for interface
to THC Sensor Card
Test LED
Test Button
16 PIN Header
Plug to UBOB
DC to DC
Power Converter
Units are calibrated
at the factory.
Actual card layout
may vary from the
photo.
The photo shows a top view of the DTHC module card. There are two connections to
make. The first is the 16 pin IDC cable between the DTHC and the UBOB Feature
Connector. It’s the only 16 pin header on the UBOB. Both headers are keyed so the
cable only fits one way. The other connection is to the DB9 socket from the THC
Sensor Card.
INSTALLING THE DTHC INTO AN EXISTING MP3000 or BladeRunner
PRODUCT
1. Locate the UBOB card in the unit. It is the card with the PORT1 and Serial
Port inputs. There is a 16 pin FEATURE CONNECTOR. Use the short 16 pin IDC
cable included with the DTHC and plug one end into the FEATURE CONNECTOR
2. Mount the DTHC to the Front Panel using the jackscrews on the DB9 Socket.
Remove both hex jackscrews and line up the holes for the TEST LED and the
TEST BUTTON. Replace the hex jackscrews through the front into the DB9
Socket and tighten until the board is snug against the inside of the panel. DO
NOT OVERTIGHTEN AND STRIP THE INTERNAL FASTENERS ON THE DB9!
It will make secure mounting difficult. The threads on the jackscrews are 4-40.
3. Hold the back of the DTHC Card and insert the other end of the 16 pin IDC
cable from the UBOB card FEATURE CONNECTOR Header.
4. Proceed to DTHC preliminary testing
PAGE 3