Rev 1.0
31
However, if you want your display to show the same value as your speedometer, you can use the
multiplier (see chapter 8.1). If you want your display to show 100 km/h instead of 95 km/h, you must
adjust the multiplier to 1,053 (100/95).
𝑣𝑎𝑙𝑢𝑒 𝑠ℎ𝑜𝑢𝑙𝑑
𝑣𝑎𝑙𝑢𝑒 𝑖𝑠
= 𝑚𝑢𝑙𝑡𝑖𝑝𝑙𝑖𝑒𝑟
Of course, the same applies to Can Bus
sensors
such as power or torque.
9.7
How can I perform a reset
If your device is no longer accessible or frozen, you can try to get it back to life by resetting. To
perform the reset, you must hold down the right button before turning on the ignition.
Now your display does not start as usual but asks if you want to perform a reset. With the left button
you confirm the reset, with the right button you cancel the process. If you only want to get access to
the oDSS , you can activate the hotspot here by pressing both buttons for a long time and add new
firmware to your display from the
oDSS
.
