Rev 1.0
15
6.1.4
Pages
In the sub-item
Pages
you can configure the appearances of your up to eight
pages
. Here you can
choose from seven different, predefined views and hide
Pages
completely. In addition, you can
activate the animation of your
sensors
to simulate the behavior during operation.
Depending on the selected view, you can be displayed by one to six
sensors
per
page
. You can
activate the display of the maximum value for each
sensor
individually and also change the colors of
the needles or bars for numerous views. Figure 14 shows the
Pages
interface of the
oDSS
.
Figure 14: Pages
6.1.5
Shift light
To configure your shift light above the OLED, you have to open the sub-item
Shift light
.
In this menu you can configure the speed at which the shift flash should flash, the general brightness
of the shift flash and the colors at the corresponding speeds. A screenshot is shown below.
Figure 15: Shift light
6.1.6
Gears
Your MFD15 Gen2 can also be used as a gear indicator. To do this, please select the page for gear
display in the Pages submenu.
The gear can either be transmitted as a can bus message, or gear can be calculated from the
sensors
speed and rpm.
For the display of the gear via Can Bus message, the corresponding sensor values must be entered.
For the gear calculation from speed and rpm, the
sensors
Speed and RPM must be assigned
appropriately (Figure 16) and the appropriate gear ratios entered in the
Gears
submenu.
