Note:
The DSP device is mutually exclusive with the AMP and ADC device. If you
have specified a DSP device address, then MCA control software will not al-
low you to communicate with an ICB AMP or ICB ADC. On the other hand,
if you have not specified the DSP device address, the software will allow you
to control an AMP and or ADC. You cannot use a DSP in conjunction with ei-
ther an AMP or ADC.
When you select the DSP Module option, you will see a dialog like the one shown in
Figure 15. Each of the setup parameters should be set up to match the device/detector
configuration that you will be using. A description of each of the parameter settings is
provided here in this chapter. In addition, a table of the suggested default values for all
of the parameters is provided at the end of this section.
Chapter 4 - Genie VMS User Interface and Controls
20
Model 9660-9660A ICB Digital Signal Processor
Figure 14 Standard Parameters Editor
Main Menu
