2
Instructions
The first Step to wellness
Preparing the AroMed ooo Vaporizer
- Wash out the waterfilter (1) and fill in a finger digit of water. Connect silicone tube
and mouthpiece.
- Fasten the Waterfilter (flat side to electronic box) with the encluded rubber band
(2). Avoid splashing water!
- Fill desired into the holder(3). Make sure there is a space of at least 5mm between
the material and the glass of the heating element.(4).
- Now bend flexible arm with the heating element (4) into the holder. Touch the grip
(5) carefully only above the groove. Press the grip onto the holder until they click
together.
- Connect the AroMed
ooo Vaporizer with DC current (90 to 250 Volts, 50 to 60
Hertz) with the net supply cable (6).
- The display (7) shows
„standby“ („----“)
Vaporizing
- Press the red button (8) at the front panel. Choose wanted vaporizing temperature
with the plus+(9) and minus-(10) buttons. For optimum temperatures see plant index.
- While in the heating phase, a red dot is glowing constantly on the upper left side of
the display. When the red dot is blinking, the system is heated to the chosen
temperature. Now you can inhale soft and deeply. The red dot should blink all the
time. If you inhale too hard, the red dot will glow permanently.
- Watch the plant material: if it is getting dark brown, the chosen temperature is
definite
ly too high, adjust by pressing the “-“ button.
- To switch off the AroMed ooo Vaporizer press the red button. The last chosen
temperature will be stored. Pull the power supply cable, when not in use.
- We advice to clean the silicone tube, waterfilter and mouthpieces in boiling water or
desinfect with proper desinfection lotion after use.
