Model # MMRC190
INFRARED REMOTE CONTROL MIST MAKER
INSTRUCTIONS MANUAL
Thank you for purchasing Canary Products. Please read the instructions manual
carefully before operating.
FEATURES & FUNCTIONS
MMRC192 has both inline control and remote control
You can use both the inline and remote control to select the color
of your choice.
Or you can simply turn off the color if you choose to do so.
You also have the option of controlling the amount of mist it
produces: low-medium-high
Please see the complete instruction for use of the remote and inline
control below.
TECHNICAL DATA
Working Voltage
(VAC)
Working Electric
Current (A)
Ultrasonic
Frequency(KHz)
Ceramic disc
spec. (mm)
24
0.60~ 0.70
1700
±
40
Φ
20
Generate mist
(ml/h)
Water temp. Range
(
℃
)
Lifespan of Ceramic
Disc ( hour)
≥
250
15 ~ 50
>2000
OPERATING PROCESS
1.
Place the MIST MAKER into a water container.
2.
The water level sensor switch (please see drawing 1), must be completely
submerged under water (about 1/4 –1/2 inch is optimal). If submerged any further
than ½ inch than the mist will not work optimally.
3.
Connect the mist maker with the inline control.
4.
Connect the inline control with the adapter.
5.
Plug in the adapter into your outlet.
6.
If there is no mist or the LED lights are not operating, please note that you do not
have enough water, as it is not submerged completely.
NOTICE & CAUTION
1.Please DO NOT hold or pick up the fogger unit with its water level sensor. DO
NOT scratch or bump the water-level sensor as it could permanently damage the
unit.
2. Don't move the fogger unit or pull its cable while it's working.
3. Don't put your hand above the ceramic disc of the mist maker. The vibration can
shock you, but it is not an electronic shock.
MAINTENANCE & SERVICE
a.
Be sure to pour clean and filtered water and replace water in the glass bowl timely.
b.
Clean the ceramic disc and the surface of the mist maker with soft cloth or cotton
sticker in clean water once a month. DO NOT touch or scratch the ceramic disc or
the water lever sensor switch. DO NOT use washing powder to clean any part of
the mist maker.
c.
If the unit cannot generate mist after running for some time, please check and
confirm there is enough water in the bowl. If the LED light is also off and not
creating mist, please make certain that it is receiving electricity and check the on
and off switch.
d.
If the unit cannot generate mist, but only spraying water, the unit is good, the water
in the bowl may be dirty. Simply replace the water in the bowl, it should start
working normally. If it continues to spray, but not mist, please make sure the level
of the water is not higher than ½” above the water level sensor.
e.
After running some time (approximately 1500 hours), the mist will start to reduce.
