J
Position
stopper
I
I
K
STEP 4
Take both cross boards (F). These are to be fastened underneath the chair legs (E).
Set a plank in the foremost notches and secure it on each side with a 4x40 mm
screw. Secure this in the same way as the other plank in the notches at the back of
the legs. Make sure that the countersunk edge of the pre-drilled holes is facing
upwards.
STEP 5
The next step is to construct the armrests. Fasten the triangle (G) to chair leg (E)
using two 4x40 mm screws. The two marked holes at the side of the triangle are
reference points. The triangle should stick out 1.5 cm above the chair leg. The
three marked holes on the triangle should face the front. Secure the hinge with a
small hinge screw in the middle of the three holes. Secure the armrest opposite to
the hinge. Use only
one
screw in the middle hole. Repeat on the other side of the
chair.
STEP 6
Now put the 'position stopper' together. Set the parts (I) onto the right and left
side of the upper back support. Fasten the planks through the hole on the top of
planks (I) using a large screw and a washer. Do NOT over tighten the screws. Part
(J) must still be flexible. Now place slat (K) directly underneath part (I) and secure
it using two 4x40 mm screw on each side.
F
F
K
