F
incorrect
correct
I
1
¼
’’
STEP 4
To assemble the armrests: Fasten triangle (G) at the top of chair leg (E) from
the inside to the outside with two 4x40 mm screws. Place the triangle in the
middle and make sure that the topmost point of the triangle is parallel to
the upper edge of the chair leg. Set part (H) on top. Use four 4x40 mm
screws to fasten part (H) onto the chair leg and the triangle. Repeat on the
other side of the chair.
STEP 5
Now secure the armrests. Place the armrest (I) on the armrest frame. Fasten
the end of the armrest onto the inside of back support (F) with a 4x40 mm
screw. Make sure that the front of the armrest is resting flat on the support.
If necessary, slide the leg slightly forwards or backwards so that it is parallel
to the back support. Do NOT over tighten the screws. Take the smaller 4x30
mm screws; screw four of these through part (I) from underneath the
armrest on each side.
STEP 6
Secure the upper back support (J) with one 4x40 mm screw on each side to
the top of both of the upright back supports (F). Make sure that the rounded
side is facing inwards. The back edge of the topmost back support (J) should
be flush with the lower rearmost edge above planks (F). The pre-drilled
holes should be in the middle at the top of planks (F). Naturally, the
countersunk edges of the holes should face upwards.