Instruction for Surface Installation
CANAAN INC.
1. Drill the proper size and depth hole.
That the holes are too large can usually be detected earliest when the wedge anchors moves
forward by more than a fraction of an inch (1/4” max) during tightening.
2. Clean all the dust out of the hole with a blower or similar tool.
3. Hammer the expansion bolt into the hole.
Gently tap the wedge anchors until it is at the bottom of the drilled hole.
Two or three solid blows to compact the lead.
4. Tighten the nuts firmly.
Make sure the nut has not been over tightened; otherwise you can cause unnecessary stress on
the wedge anchors and cause it to break.
Instruction for Surface Installation