CAN PC Series, Manual Instruction

Page: 10 / 48

10
Replace everything necessary, always fitting original parts supplied by Technical Assistance. The washers in contact with gas
(e.g.: those of the valves) must always be replaced when implicated in disassembly).
Restore any seals when the replacement operation is complete.
If it becomes necessary to replace the injectors, see the TECHNICAL FEATURES section. No sealant is used between the injector
thread and its seat.
Figure 4
Valve Copper ramp
Stainless steel ramp
Cut-off device injector cup
Proceed with reassembly.
Greasing the valves: if the rotation of the knob becomes difficult, it is necessary to grease the valve to prevent damage. Proceed
as follows:
- dismantle the valve from the gas ramp and the internal tubes;
- dismantle the body of the valve;
- remove the conical male element, cleaning it with thinner;
- lightly re-grease the cone using appropriate grease;
-
introduce the cone into its seat, manoeuvring it to expel any excess grease. Remove the excess grease with a cloth;
- remove the cone again to ensure that the grease has not blocked the internal gas passages;
- refit the valve.
AFTER COMPLETING EACH REASSEMBLY, ALWAYS CHECK THAT THE SEAL CONFORMS TO THE INSTALLATION
STANDARDS IN FORCE.