Version v0.2
www.canchecked.de
Installation
When installing the display, you need to pay attention to a neat cabling. The power
cable needs to be fused with 5A. The measurements for the mounting hole and the
screw holes can be found in the upper drawing.
In addition, only the can bus cables (high/low) needs to be connected.
Please make sure, to tighten the orange screws for the bracket carefully. Otherwise
you will damage the casing.
Implementation
After the start-up, the splash screen appears with the logo and an internal component
test (can bus) is run.
The display starts with the last selected view. If you press the encoder, the display
stops and shows a bar in the upper area.
1)
Shift light or warning LED
(RGB)
2)
Menu bar (if display is stopped)
3+4) current data display depending
on the selected view
If you rotate the encoder, a red
rectangle is shown with the current
position. With another press, you
select the action:
1-8: change view
Setup: Setup / Menu
3+4: Change the sensor
The view of the data is selected in
menu under “views”. Choose
between: single value, 2 values, 4
values, 6 values, bargraph, YT
diagram, single needle, double
needle, bar+2way
On questions regarding accessories or functionality please get in contact with us via
our homepage (
www.canchecked.de
) or via email (
).
1
3
2
1
1
3 4 5
6
7 8 Setup
3540
4
0.98
RPM
Lambda1
2
