UNCRATING
NOTE:
The steps that follow describe two meth-
ods for lifting the front of the vehicle from the
crate base. The conventional method uses a hy-
draulic jack and the alternate method uses a chain
block. Use the proper method according to your
shop layout.
Conventional Method
1. Remove piece of wood located at the front of
the vehicle.
NOTE:
The removed piece of wood can be used
to level the jack in the following step.
rbl2013-003-003_a
TYPICAL
1. Wood piece to remove
2. Install a floor jack with a piece of wood on top
to increase contact surface of jack pad.
rbl2013-003-004_a
TYPICAL - FRONT OF VEHICLE
1. Jack
2. Wood piece
3. Wood piece removed earlier
CAUTION
Approach with care when vehi-
cle is on the jack as it may be unstable.
3. Lift the vehicle.
rbl2010-002-016
TYPICAL
NOTICE
Never lift vehicle by the suspension
arm.
Alternate Method
1. Install proper straps with hooks on RH and LH
lateral supports of vehicle.
NOTE:
Insert hooks through the holes in the
frame.
rbl2013-003-005_a
TYPICAL
1. Strap
2. Hook
3. Frame
2. Hook straps on an appropriate lifting kit.
3. Lift vehicle using a chain block.
NOTICE
Never lift vehicle by the suspension
arm.
Front Wheels Installation
1. Clean front and rear brake discs.
PREDELIVERY
2014-1
9 / 52
