UNCRATING
UNCRATING
Crate Cover Removal
NOTICE
Allowing the crate to drop may cause
serious damage to vehicle.
1. Position the crate on a firm, level surface.
2. Carefully cut both ends of crate tarpaulin to lo-
cate the rear of vehicle.
rbl2010-002-001
CUT BOTH END OF CRATE TARPAULIN
3. Remove all screws holding crate cover to crate
base.
4. Tilt cover from the rear side of the vehicle.
NOTICE
Do not raise cover vertically. Tilt
cover located on the rear side of the vehicle.
Refer to illustration.
rbl2010-002-002
TILT COVER THEN PULL IT
NOTICE
The crate cover must be pulled to-
ward the outside while lifting it to avoid to
damage vehicle.
NOTE:
Screws that are used are Robertson
†
#2
type (or equivalent) that require the use of an ap-
propriate screwdriver.
Sub-crates Removal
NOTICE
Be careful not to scratch the cover
bumper and the front fascia.
NOTE:
The sub-crates are located on each side of
the vehicle.
1. Remove protective foam from vehicle.
2. On LH side, remove all screws holding front
storage compartment sub-crate.
3. Assisted by another person, carefully lift up the
LH sub-crate.
rbl2008-003-300_a
TYPICAL - LH SIDE
1. Sub-crate that contains front storage compartment
4. On RH side, remove all
nails
holding front
fender sub-crate.
rbs2011-014-001
NAILS REMOVAL
5. Assisted by another person, carefully lift up the
RH sub-crate.
† Robertson is a registered trademark of Robertson Inc.
4 / 37
2012-1
PREDELIVERY
