PARTS TO BE INSTALLED
rbl2010-002-032
TYPICAL
15. Reinstall the LH rear panel.
15.1 Plug turn signal connectors.
15.2 Secure panel with previously removed
screws and plastic rivets.
NOTICE
Do not overtighten screws. Any de-
formation on the panel around the screw head
is an indication that it is too tight. Be careful
not to damage the panels.
Front Storage Compartment
1. Open front storage compartment cover.
2. Remove plastic rivets securing front panels.
rbl2008-003-100_d
FRONT PANELS PLASTIC RIVETS LOCATION
3. Remove and discard bolts holding the bottom
and the top sections of sub-crate.
rbl2008-003-204_a
1. Lower retaining bolt
2. Upper retaining bolts
4. Cut locking ties securing horn and AAPTS har-
ness to frame.
5. Free the front storage compartment cover ca-
ble.
rbl2011-002-006_a
1. Horn harness
2. AAPTS (Ambient Air Pressure and Temperature Sensor) harness
3. Front storage compartment cover cable
4. DLC (Diagnostic link cable connector)
CE Models — Countries with Left-Hand Traffic
6. Before installing storage compartment, replace
the low beam lights. Refer to
LOW BEAM
LIGHT (CE MODELS)
.
All Models
7. Assisted by another person, position front stor-
age compartment into support slots of vehicle.
NOTE:
Ensure that all cables are accessible prior
to installing front storage compartment.
8. Secure the front storage compartment.
– On TOP, use four M6 x 20 hexagonal flange
screws
– At the bottom, use two M6 x 12 hexagonal
flange screws.
8 / 37
2012-1
PREDELIVERY
