Camtraptions PIR Motion Sensor v3 - Stills Mode Manual
Page 5
3-shot Burst Mode
In 3-shot Burst Mode, the PIR will always send 3 trigger signals.
The time dial sets the shot frequency from between 1 frame every
second (fully anti-clockwise) to 1 frame every 7 seconds (fully
clockwise).
If a day or night luminosity cut off is set then the gap after each burst is
2 seconds. Otherwise, the Luminosity Dial sets the gap after burst from
between 2 seconds (fully anti-clockwise) to 30 seconds (fully
clockwise).
Switches 4 to 6: Transmitter Programs
There are 8 Transmitter Programs to support different cameras and camera
settings. These programs are selected via configuration switches 4, 5 and 6.
The table below shows the switch position and corresponding program
numbers:
Program 1: Standard
Wirelessly triggers a camera on the PIR Wireless Channel.
Program 2: Wake Flashes on CH+1
Wakes flashes on the flash channel (PIR Channel plus 1) and then
triggers a camera on the PIR Channel.
This allows any camera to be used as a still camera trap triggering
flashes connected to wireless receivers. See Page 3 for more.
