www.camsat.com
Wireless video and audio transmission system for IP
cameras HD and UHD in the band 5.1 - 5.8 GHz with
internal antenna, and output to an external antenna.
QUICK START
ver. 1.1
LINK INFORMATION
It contains basic information about the settings of the radio eg. the name of the radio link,
signal strength and a list of connected radio transmitters.
CAMERA CONNECTION SETTINGS
Wireless – Contains settings of radio link such as transmission type (Master / Slave),
the frequency of the operating channel, the name of the link SSID, signal strength,
coding of transmission.
Network Settings – Contains settings of IP networks.
1. Menu tree panel Website
Time Zone Setting - set the time, the NTP server
System Log - an overview of recent developments and changes in the device CDS-6IP/SMA
Upgrade Firmware - Software Update
Backup/Restore -
save / restore configuration of system
ADVANCED SETTINGS
6. The recommended configuration settings:
7. Test the radio link.
These steps must be repeated for each individual transmitter / receiver
subsequently connecting them to your computer.
EU
EU
POLISH
MARK
POLISH
MARK
Password - change the password
Full instructions can be found at www.camsat.com and on the CD
1
4
Full instructions can be found at www.camsat.com and on the CD
2. Factory settings
a) Change the password to log on to the web panel (
ADVANCED SETTINGS / PASSWORD
)
b) Enter the password encryption of radio transmission - a recommended coding WAP2-PSK
(
CAMERA CONNECTION SETTINGS / WIRELESS
)
c) Scan free channels - set the Receiver in operating mode
Slave
.
Save and press Scan Masters to scan the busy channels.
With this information, you will learn which channels in a given area are free or at least occupied.
In the absence of free operating channels it is allowed to use multiple radios on the same channel,
then select the channel with the weakest signal (below <-65dB)
The last step is to check the correctness of transmission between devices. To check the information
regarding connected devices CDS-6IP/SMA such as signal strength, connection time, speed, IP
address, etc. you must enter the
LINK INFORMATION
.
To view an updated list of current connections, click the Refresh button at the bottom or press F5. The
appearance of the list of MAC addresses of transmitting units in the receiver indicates the correctness
of the radio configuration. To be sure, disconnect the computer from the transmitter unit and connect
the IP camera.
If the devices communicate with the receiver, this means that the radio connection is properly configu
-
red and running. In the browser address bar enter the IP address of the camera and check the quality
of image transmission. You can assembly units at the facility.
Do not use AUTO channel settings. Be sure to select the channel number on a permanent
according to the current network bandwidth consumption.
Warning
!
NOTE: Before first use, it is necessary to check the full user manual
Full user manual can be found at: www.camsat-cctv.com
5. The necessary configuration settings - required:
a) Log on to the radio module CDS-6IP/SMA (default: 192.168.1.1,
Username
: CAMSAT,
Password
: CAMSAT).
b) Set the IP address of the radio module.
c) Set the mode
Master
(Receiver-Recorder) or
Slave
(transmitter - camera).
d) In the receiver (
Master
), set the operating channel number
e) In the transmitter (Slave), press the
Scan Masters to find name of
radio link SSID of a receiver. Select the name of the link SSID and press
Connect
. Repeat this step
for all transmitters (Slave) to be connected to the receiver (Master)
f) correctly connected transmitters should be visible in the list of linked devices in tab
System Information / Wireless clients
g) In the transmitters, set the real distance between the transmitter and receiver. In the receiver,
set the distance of the furthest transmitter.
h) Check the connection between the transmitter, the receiver in the tab, cameras and DVR by PING.
