4
ASSEMBLY INSTRUCTIONS
READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS
CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR STOVE.
Inspect contents of the box to ensure all parts are included and undamaged.
Step 1
Snap down the lid arms on the bottom case.
Step 2
Open lid and align the two wind guards by
inserting notched support arms into wind guards.
Step 3
Make sure burner control knobs are in “OFF”
position.
Step 4
Attach regulator assembly to stove fittings. HAND
TIGHTEN ONLY, Do not cross-thread connections.
Step 5
Attach propane/butane cylinder to regulator
assembly by turning propane/butane cylinder
counter-clockwise.
HAND TIGHTEN ONLY. Do not cross-thread
connection.
CAUTION:
Turn cylinder so that it is fully
upright. The cylinder must always sit
flat on surface. See diagram below.
Step 6
Follow “
Gas Link Testing
” instructions on page 5
of this manual.
5 to 10 cm
NOTE:
Propane/Butane cylinder should be
positioned at a minimum of 5 to 10 cm
from stove. Always use a cylinder with a
flat bottom.
●
Type of gas: PROPANE at 37mbar/BUTANE at
(28~30) mbar.
●
Gas category: I
3+(28~30/37)
●
Gas cylinder : Operates off 2.7 to 15 kg butane/
propane cylinders. Maximum cylinder diameter:
32 cm. It may be hazardous to attempt to fit other
types of gas containers.
●
Gas hose: In accordance with national legislation
and standards (max 1.5m).
●
Gas regulator: In accordance with national
legislation and standards (max flow rate 1.5 kg/h).
The regulator must comply with EN16129.
●
Orifice diameter: 0.60mm
Cooking Grill
Notched Support Arm
Burner Control Knobs
WARNING:
Always snap down the lid arms on
the bottom case to prevent the stove
from becoming unstable while in
use.
