GB
S. TROUBLESHOOTING
Problem
Troubleshooting
Corrective Actions
Difficulty in lighting up
y
Check that the regulator matches the type of
gas and recommended pressure.
y
Check that the regulator is not in safe mode.
y
Check that the regulator and hose are in good
condition.
y
Check that the cylinder is not empty or almost
empty.
y
Change the regulator if it does not match.
y
Reset the regulator.
y
Replace the hose and/or regulator if they are in
poor condition.
y
Change the cylinder if necessary.
Difficulty in lighting up
The flames are not
stable when a new
cylinder is used.
y
Possible presence of air in the cylinder and
thus in the gas circuit.
y
Let the barbecue work and the problem will
disappear.
The burner will not
light.
y
Check that the hose, injector, tap, venturi tube
and burner holes are not clogged.
y
Blow in the burner.
y
Clean the Venturi tube.
The burner does not
burn smoothly or goes
out.
y
Check that there is sufficient gas in the
cylinder.
y
Change the gas cylinder.
Large flame on the
burner surface
y
The burner outlet may be blocked (spider
webs,...) or the injector holder is improperly
positioned in the outlet.
y
Clean the Venturi tube and/or reposition the burner.
Flame at the injector
y
Check that the cylinder is not almost empty.
y
Change the cylinder.
y
Contact the After Sales Service.
Insufficient cooking
temperature
y
Check that the injector or Venturi tube is not
blocked (spider webs...).
y
Clean the Venturi tube.
The grease ignites in
an abnormal manner.
y
Make sure grease has not accumulated at the
bottom of the grill.
y
Reduce the gas flow of the barbecue.
y
Clean the bottom of the grill.
The burner does not
light up with the piezo
ignitor.
y
Check the condition of the wires or electrodes.
y
Check that the piezo ignitor is well connected
to the electrode.
y
Change if necessary. Contact the After Sales
Service.
y
Connect if necessary.
Flame at the
connection of the gas
hose with the nozzle
y
Check the air tightness of the coupling.
y
Check for the presence of the flat seal.
y
Close the gas supply.
y
Contact the After Sales Service.
y
Change the flat seal.
Flame behind the
adjustment button
(knob) or control panel
y
Turn the appliance off and close the cylinder.
y
Contact the After Sales Service.
11
Summary of Contents for ATTITUDE 2go
Page 4: ...3 FIG 7 FIG 8 FIG 9 FIG 4 FIG 5 FIG 6...
Page 13: ......
