INSTRUCTION MANUAL
CamPilot MR100
4 / 52
Before sending the camera out for repair, check the items below.
If the problem persists after checking these items, contact your service center.
▲
If no image appears
- Is the LAN cable attached securely?
- Are the power and voltage normal?
- Has the iris of the lens of the camera been adjusted correctly?
(with the level volume)
- Is there adequate illumination?
▲
If the image is unclear
- Is the lens in focus?
- Is the lens dirty?
- Dirt or fingerprints on the lens can adversely affect the images.
Gently wipe any dirt or fingerprints off the lens with a soft cloth or lens
cleaning paper and cleaning fluid (commercially available).
- Is the monitor adjusted correctly?
▲
If the Audio is not work
- Is the audio cable attached securely?
- Are the connected devices(amplifier, microphone, speaker and etc.) normal?
- Are the Client software and devices normal?
▲
If the Pan/Tilt control is not work
- Is the RS485 cable attached securely?
- Is the connected PTZ driver normal?
- Is the RS485 control setting(Protocol, Baudrate, Control ID and etc.) correct?
▲
If the DIO is not work
- Is the DIO cable attached securely?
- Is the connected sensor or alarm device normal
TROUBLESHOOTING
