TB4 and TB4MM Tipping Bucket Rain Gages
8
FIGURE 7-3. Pedestal Base Options
7.5 Leveling
After mounting the rain gage, use the following procedure to level it.
1.
Remove the housing assembly from the base by loosening the three
housing screws and lifting the housing upward.
2.
Adjust the three leveling screws on the CM240 bracket to level the gage
(FIGURE
). A bullseye level is mounted on the rain gage’s base to
facilitate leveling (FIGURE
FIGURE 7-4. CM240 Mounting Bracket
Leveling Screw
Leveling Screw
Leveling Screw
