Campbell PVS5120 Series, Instruction Manual

Page: 50 / 102

PVS5120-Series Portable Samplers
38
FIGURE 8-9. MD485 CS I/O tab
6. Click the RS-485 tab. Set Baud Rate to 38.4 kbps. Set Parity to None .
Set Character Length to
8 bits
. Set Stop Bits to
1 bit
(FIGURE 8-10 ).
FIGURE 8-10. MD485 RS-485 tab
7. Click Apply .
8.2.4.2 Configuring Sampler for PakBus® Control
1. Once connected to the VSC100 in
DevConfig
, click the Sampler Settings
tab (FIGURE 8-11 ).
a. Set the Control Type to PakBus .
b. Set the PakBus Address . This is the address of the sampler and is
referenced in the
CRBasic
program running on the datalogger. The
default PakBus® address for the samplers is 95. Each sampler needs
to be uniquely addressed, as well as each datalogger on the network.
c. Set the Number of Sampler Bottles .
d. Set the Samples Per Bottle . It can range from
1
to
999
. This setting
is ignored if
Never Full
is set to On/Enable .