OBS-3+ and OBS300 Suspended Solids and Turbidity Monitors
5.
Under the
Available Sensors and Devices
list, select the
Sensors |
Water | Quality
folder. Select
OBS3+/OBS300 Turbidity Sensor
. Click
to move the selection to the
Selected
device window. Select your
sensor’s
Low and High NTU Range
and
Maximum Voltage Output
.
You can use the default value (V) for the
Coefficients based on signal
voltage in units of
. Enter the
Low Range Coefficients
and
High Range
Coefficients
according to your calibration sheet (see Section 7.5,
Calibration Certificate
).
6.
After selecting the sensor, click at the left of the screen on
Wiring
Diagram
to see how the sensor is to be wired to the datalogger. The
wiring diagram can be printed out now or after more sensors are added.
7.
Select any other sensors you have, then finish the remaining Short Cut
steps to complete the program. The remaining steps are outlined in
Short
Cut Help
, which is accessed by clicking on
Help | Contents |
Programming Steps
.
4
Summary of Contents for OBS-3+
