Campbell Company
906-0003 AGPS Installation Manual Rev D.docx
Advisor Guide Pedestrian Signal
[Version D]
Document Name: 906-0003 AGPS Installation Manual Rev D.docx
Page 13 of 15
© Company 2014. All rights reserved
3
Post Installation
3.1
Operational Check
1. The AGPS comes fully configured at the factory. When first powered up, an audible
locator tone will be present.
2. Depress the push button and verify the red LED turns on with an audible message “Wait”.
(No acknowledgment message in EPAPS mode). If field wires from the traffic controller
are connected to the station, verify that pedestrian call is transmitted to the traffic
controller.
3. Following a momentary press, verify the Walk Phase message or percussive tone is
present and the vibro-tactile button vibrates concurrently when the walk sign is on.
4. Repeat again with 2 second extended press and verify the red LED turns on with an
audible location message.
5. After the Walk Phase message, verify an audible locator tone is present at the clearance
phase (Flashing Don’t Walk).
6. Recheck all units for a full cycle to ensure all options and features operate as desired.
7. Depending on intersection location, factory default settings for volume, AGC, and vibro-
tactile settings may require modifications. Proceed to the System Configuration section for
details.
3.2
Operational Check List
____ Base Station is securely attached to the pole (extension bracket) with the arrow pointing to
the destination.
____ Audible “Walk Tone / Message” is present when call is placed and Walk Sign is on.
____ Locator tone is present when no call is placed.
____ Locator tone is audible 6 to 12 feet or building line whichever is less from ped station.
____ Messages are audible to a distance of 6 to 12 feet from pedestrian station.
____ Correct message for the Walk Cycle is present (Percussive Tone / Verbal Message)
____ Correct messages is present for location and walk
____ LED is lit when call is placed
____ Vibro-tactile arrow is active when call is placed and walk cycle is active (only when VIB is
enabled in the utility)