Campbell GPS16X-HVS, Instruction Manual

Page: 10 / 38

GPS16X-HVS GPS Receiver
DGPS (USCG/RTCM)
Position: 3-5 m, 95% typical
Velocity: 0.1 knot RMS steady state
DGPS (WAAS)
Position: Less than 3 m
Velocity: 0.1 knot RMS steady state
PPS Time: ±1 microsecond at rising edge of PPS pulse (subject to
selective availability)
Dynamics: 999 knots velocity (limited above 60,000 ft, 6g
dynamics)
Interfaces: True RS-232 output, asynchronous serial input
compatible with RS-232 or TTL voltage levels, RS-232
polarity. Selectable baud rates (4800, 9600, 19200,
38400)
PPS: 1 Hz pulse, programmable width, 1 microsecond
accuracy
Power Control
Off: Open circuit
On: Ground or pull to low logic level < 0.3 volts
Environmental Characteristics
Temperature: -30° to +80°C operational, -40° to +80°C storage
3. Wiring
The GPS16X-HVS connects directly to a CR800, CR850, CR1000, or CR3000
datalogger (see TABLE 3-1). Refer to Appendix B.1 if connecting the receiver
to a CR23X. Our CR5000 and CR9000X connect to the receiver via the
SC110 and an SDM-SIO4 (see Appendix C).
If the GPS16X-HVS is to be connected to a computer to change the default
settings, an A200 or SC110 cable is needed (see Appendix A).
4