Campbell ENC 10/12, Product Manual

Page: 44 / 51

FIGURE C-2. Mounting a CR6 above a BP7 with the hinge closed and with the hinge
opened
The Hinged Enclosure Stack Mounting Kit consists of a hinge plate, hinge pin, two legs, four
grommets, and four screws (
FIGURE C-3 (p. 39)). The component to be raised is mounted directly
to the hinge plate using the grommets and screws. The plate has the same half-inch diamond
grid pattern for the grommets found in Campbell Scientific enclosures. This allows the raised area
to be tailored to the component size.
FIGURE C-4 (p. 39) shows a fully assembled stack mounting
kit without any components.
Enclosures 38