CM106B Tripod
16
Install the U-bolts, flat washers, lock washers, and nuts (FIGURE
).
Tighten the nuts until the lock washers are compressed.
Route the 14 AWG wire from the ground lug on the bottom side of the
enclosure to the ground lug on the base of the tripod (FIGURE
). Strip
1.2 cm (0.5 in) of insulation from each end of the wire. Insert wire ends into
the ground lugs and tighten.
FIGURE 6-11. Enclosure with the –MM bracket
6.1.7.2 Enclosure Mounting to Tripod Leg
For a video showing how to mount an enclosure to a tripod leg, see
www.campbellsci.com/videos/tripod9
An enclosure ordered with the –LM bracket has a bracket on each side of the
enclosure, and a U-bolt bracket for securing the enclosure to a tripod leg.
Attach an enclosure with the –LM mounting bracket to the tripod base as
follows:
Slide the keyhole notch in upper corner of the –LM bracket over the extended
hook located on the tripod base as shown in FIGURE
, and engage the
notch in the lower corner of the –LM bracket with the enclosure tab. There are
six places on the tripod base with provisions for mounting enclosures with the
–LM brackets.
Lock Washers
U-Bolt
MM Bracket
Nuts
