Campbell CC5MPXWD, Instruction Manual

Page: 26 / 126

CC5MPX Digital Camera
14
FIGURE 7-2. CC5MPX Mounting Kit
When using the optional mounting kit (pn 18549) as shown in FIGURE 7-2 ,
align the outer holes of the CC5MPX with the center hole and the 180° slot of
the mount. Loosely secure the two together with the two ¼-20 x 0.5 in. Hex
bolts, lock washers, and washers included with the kit. It is now possible to
mount the CC5MPX to either a crossarm or other mounting surface with the
included U-bolt.
With the hardware loose, the camera and the 18549 mounting kit can be
pivoted to allow a full range of motion when aiming the camera. The hardware
should be secured once the camera is properly aimed at the intended target
(FIGURE 7-3 ).
The focus of the camera should be checked and adjusted as required. Refer to
Section 8.11.2 , Focus and Zoom Adjustment
(p. 88)
, for details. Be sure that the
lens tube is fully seated, the sun shroud is properly oriented after the camera is
aimed, and any protective caps are properly secured.
The sun shroud can be adjusted by loosening the Philips screws and turning the
shroud; do not over tighten the screws as the shroud may crack. A light torque
is all that is required to hold the shroud in place.