7.2 Mounting/cable strain relief
CAUTION:
Before mounting, the installers need to wash their hands and then clean the back of the PV
module or other device with ethyl alcohol.
7.2.1
Adhesive
mounting
strip
An
adhesive
mounting
strip
is
adhered
to
the
flat
surface
of
the
alumin
i
um
disk.
To
mount
the
sensor,
remove
the
paper
from
the
mounting
strip
and
adhere
it
to
the
back
of
the
PV
module
or
other
device.
The
mounting
strip
must
be
adhered
to
a
clean
surface
for
its
adhesive
to
function
properly.
CAUTION:
Do not use epoxy to secure the sensor head to a PV module.
7.2.2 Cable strain relief
The cable must be properly strain relieved after mounting the 110PV to the measurement surface.
To accomplish this, the 110PV comes with cable ties and a cable tie mount. A yellow label on the
cable indicates where the cable should be tied down (
NOTE:
Placement of the cable inside a rugged conduit is advisable for cable runs over 4.5 m (15 ft),
especially in locations subject to digging, mowing, traffic, power tools, animals, or lightning
strikes.
110PV Surface Temperature Probe
8
