Campbell 108, Instruction Manual

Page: 16 / 31

Model 108 Temperature Probe
7
Tools required for installing on a tripod or tower:
• 1/2-inch open-end wrench
•
UV-resistant cable ties
•
adjustable wrench with a minimum 1-1/2 inch jaw size
FIGURE 7-1. Installing a 108 and 41303-5A Radiation Shield on a
CM200-Series Crossarm
FIGURE 7-2. 108 and 41303-5A Radiation Shield on a tripod mast
(left). 108 and RAD06 Radiation Shield on a CM200-Series
Crossarm (right).
The 108 is held in the 41303-5A radiation shield by a mounting clamp at the
bottom (FIGURE 7-1 and FIGURE 7-2 left). Loosen the mounting clamp
screws, and insert the probe through the clamp. Tighten the screws to secure
the sensor, and route the sensor cable to the instrument enclosure.