Campbell 03002, Product Manual

Page: 10 / 30

6.3 Wind sentry assembly
Operating temperature: –50 to 50 °C assuming non-riming conditions
Overall height: 32 cm (12.6 in)
Crossarm length: 40 cm (15.7 in) between instruments (center-to-center)
Mounting diameter: 34 mm (1.34 in), mounts on standard 1 inch IPS pipe
7. Installation
If you are programming your data logger with Short Cut , skip Wiring (p. 7) and Programming (p.
9). Short Cut does this work for you. See QuickStart (p. 2) for a Short Cut tutorial.
7.1 Wiring
Connections to CRBasic data loggers are given in Table 7-1 (p. 7), Table 7-2 (p. 8), and Table 7-3
(p. 8). When Short Cut software is used to create the data logger program, the sensor is wired to
the terminals shown in the wiring diagram created by Short Cut .
Table 7-1: 03002 Wind Sentry Set wire color, wire function, and data logger connection
Wire color Wire function Data logger connection terminal
Red WS signal
U configured for pulse input
1
, P (pulse input),
or P_LL (pulse, low-level ac)
Black WS signal reference ⏚
Green WD signal
U configured for single-ended analog input
1
,
SE (single-ended, analog input)
Blue WD voltage excitation
U configured for voltage excitation
1
, EX,
or VX (voltage excitation)
White WD signal reference ⏚ (analog ground)
Clear Shield ⏚ (analog ground)
1
U terminals are automatically configured by the measurement instruction.
Wind Sentry Series 7