Campbell Hausfeld XT002000, Operating Instructions Manual

Page: 9 / 56

7
12. Check air hoses for weak or worn condition before each use. Make sure
all connections are secure.
Never carry a tool by the hose or pull the hose to
move the tool or a compressor. Keep hoses away
from heat, oil and sharp edges. Replace any hose that is damaged, weak or
worn.
Release all pressure from the system before
attempting to install, service, relocate or perform
any maintenance.
13. Keep all nuts, bolts and screws tight and ensure equipment is in safe
working condition.
14. Do not put hands near or under moving parts.
Do not misuse this product. Excessive exposure to
vibration, work in awkward positions, and repetitive
work motions can cause injury to hands and arms. Stop using any tool if
discomfort, numbness, tingling, or pain occur, and consult a physician.
This impact wrench requires lubrication BEFORE the
initial use and BEFORE and AFTER each additional
use.
Disconnect the impact wrench from the air supply
before lubricating.
After an air tool has been lubricated, oil will
discharge through the exhaust port during the first
few seconds of operation. Thus, THE EXHAUST PORT MUST BE COVERED
WITH A TOWEL before applying air pressure. FAILURE TO COVER THE
EXHAUST PORT CAN RESULT IN SERIOUS INJURY.
When reassembling be careful not to overtighten.
Bolts may fail or cause a hazardous condition. Be
sure to set the regulator to the minimum setting then use a torque wrench
to set torque.