Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and
others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for
future reference.
IN971100AV 3/02
Installation Instructions
Model WT2530
Aluminum
Welding Kit
BUILT TO LAST
Description
Model WT2530 is an aluminum welding
kit designed for use on all Campbell
Hausfeld wire feed MIG welders (WG
series). This kit includes: PTFE wire liner
(Part Number: WC600210AV) , smooth-
groove drive roller (Part Number:
WC500008AV) and four pieces of
0.030" (0.8 mm) aluminum contact tips
(Part Number: WT501800AV). These
parts, when installed in your welder,
allow welding aluminum with greater
success. Along with this kit, you will
need a spool of 0.030" (0.8 mm)
aluminum MIG wire (Part Number:
WE303001AV) and a bottle of 100%
Argon shielding gas (Part Number:
WT601100AV).
PTFE wire liner
The PTFE wire liner reduces the drag on
the soft aluminum welding wire. DO
NOT USE TO WELD STEEL. This liner
should be used for aluminum welding
only to prevent contamination.
1. Verify the welder is OFF and
UNPLUGGED.
2. Open wire feed door and locate
drive deck. Remove torch cable
cover by removing three screws (see
figure 1a). WG3020: Remove four
screws (see figure 1b).
3. Disassemble torch handle by
removing four screws (see figure
2a). WG3020: Remove one screw
and twist nut (see figure 2b).
4. Remove swan neck/valve assembly
from handle (see figure 3a).
WG3020: (see figure 3b).
5. Remove the existing wire liner from
For parts, manuals, product & service information
visit www.chpower.com
or call 1-800-746-5641
© 2002 Campbell Hausfeld/Scott Fetzer
the valve. Unlock by pulling up,
then out from the valve (see figure
4a). WG3020: Pull liner from valve
while pressing collar of liner fitting
(see figure 4b).
6. Straighten the torch hose and
remove the existing wire liner. Then,
insert the PTFE wire liner into the
torch hose.
7. Push new liner into the valve at an
angle until seated fully and then
push sideways to lock it in position
(see figure 4a). WG3020: Push new
liner into fitting. It locks
automatically.
8. Place swan neck/valve assembly into
torch handle, making sure small
black wires are located correctly (see
figure 5a). Reassemble torch handle
with four screws. WG3020: Make
sure trigger is positioned correctly
(see figure 5b).
Figure 1a – Remove these three screws
Figure 1b – Remove these four screws
Figure 2a – Remove these four screws
Figure 2b – Remove screw and twist nut
Figure 3a
Figure 3b
Figure 4a
Figure 4b
Valve
Valve
Swan Neck
Swan Neck
Summary of Contents for WT2530
Page 7: ...Notes Notas 7 Model WT2530...
Page 8: ...Notes Notas Model WT2530...
