www.campbellhausfeld.com
3
Safety Guidelines (Continued)
MODELS: PW2770, PW3270, PW4070
f. NEVER permanently engage the trigger mechanism on the
gun.
g. ALWAYS follow detergent manufacturer’s label
recommendations for proper use of detergents. Always
protect eyes, skin, and respiratory system from detergent
use.
h. NEVER disconnect the high pressure discharge hose from
the machine while the system is pressurized. To depressurize
machine, turn power and water supply off, then press the gun
trigger 2-3 times.
i. Do not remove fuel tank cap or fill fuel tank while engine
is hot or running (allow engine to cool two minutes before
refueling). Always fill the tank slowly.
j. Follow the maintenance instructions specified in the manual.
k. ALWAYS turn water supply “ON” before turning pressure
washer “ON.” Running pump dry causes serious damage.
l. Do not operate the pressure washer with the inlet water
screen removed. Keep screen clear of debris and sediment.
m. NEVER operate pressure washer with broken or missing
parts. Check equipment regularly and repair or replace worn
or damaged parts immediately.
n. Use only the nozzles supplied with this machine.
o. NEVER leave the wand unattended while the machine is
running.
Getting To Know Your Pressure Washer
RECOMMENDED USES FOR THIS
PRESSURE WASHER
◆
Patio
◆
Siding
◆
Concrete
◆
Metal
◆
Vehicles
◆
Home exteriors
◆
Building exteriors
◆
Deck
◆
Brick
◆
Asphalt
◆
Wood
◆
Garage / Shops
Figure 2 - Components of the Pressure Washer
Handle
Pump Outlet
Connection for High
Pressure Hose
Pump Inlet
Connection for
Garden Hose
Gun with
Trigger
High
Pressure
Hose
Nozzle
Holder
with Spray
Nozzles
Lance
with Quick
Connect
Oil Location (each
engine will vary)
Choke
Fuel
Cut-off
On/Off
Switch
p. ALWAYS hold gun and wand firmly when starting and
operating the machine.
q. NEVER allow the unit to run with the trigger released (off) for
more than one minute. Resulting heat buildup will damage the
pump.
r. NEVER store the pressure washer outdoors or where it could
freeze. Freezing temperatures can seriously damage the
pump.
s. NEVER tamper with the engine governor or attempt to alter
factory settings. Altering factory settings could damage the
unit and will void the warranty.
SERVICE
a.
When servicing a tool, use only identical replacement
parts. Use only authorized parts.
The
DANGER
,
WARNING
,
CAUTION
, and
NOTICE
notifications and instructions in this manual cannot cover
all possible conditions and situations that may occur.
It must be understood by the operator that caution is a
factor which cannot be built into this product, but must
be supplied by the operator.
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
