Injection
hazard.
●
Keep clear of nozzle. NEVER direct
high pressure spray at any person,
animal or self.
●
Always wear safety glasses or goggles
and protective clothing.
Explosion
hazard.
●
NEVER spray flammable liquids or use
pressure washer in areas containing
combustible dust, liquids or vapors.
Equipment
damage.
●
ALWAYS turn water supply “ON”
before turning pressure washer
“ON”. Running pump dry causes
serious damage.
●
NEVER allow the unit to run with the
trigger released (off) for more than
one minute. Resulting heat buildup
will damage pump.
●
NEVER store the pressure washer
outdoors or where it could freeze.
The pump will be seriously damaged.
●
Release the trigger when changing
from high to low pressure modes.
Failure to do so could result in
damage to the nozzle.
●
If an extension cord is needed, the
appropriate wire sizes must be used
(See chart).
●
This unit must always be used in the
horizontal position.
EXTENSION CORDS
If using an exten-
sion cord, use only
grounded, three wire extension cords
that are in good condition.
Use only extension cords that are intend-
ed for outdoor use. These extension
cords are identified by a marking
“Acceptable for use with outdoor appli-
ances; store indoors while not in use”.
Use only extension cords having an elec-
trical rating not less than the rating of
the product.
Do not use damaged extension cords.
Examine extension cord before using and
replace if damaged. Do not abuse exten-
sion cord and do not pull on the cord to
disconnect. Keep cord away from heat
and sharp edges. Always disconnect the
cord from the receptacle before discon-
necting the product from the extension
cord.
Note
: Do not use 16 or 18 AWG exten-
sion cords on this product.
Tools Required for Installation:
●
Flat Screwdriver
●
Hammer/Mallet
●
Adjustable Wrench
1. Set plastic spacer (included in parts
pack) on workbench (Figure 1).
2. Place “star shaped” retaining ring on
the spacer (tangs pointing down)
(Figure 2).
3. Tap the retaining ring onto the axle
(Figure 3 & 4).
4. Put both wheels on axle, solid sides
together (Figure 5).
5. Attach opposite ring in the same
manner (Figure 6).
6. Slide wheels out and snap axle into
place on the underside of body
(Figure 7).
7. Snap wheel covers on the wheel.
8. Attach foot to front of pressure wash-
er body (Figure 7).
9. Hook up chemical suction hose to the
tip on the bottom of the handle
(Figure 8).
10. Attach black handle with enclosed
screws and washers (Figure 9).
3
Extension
Allowable length
Cord size
25’
50’
14 AWG
Yes
No
12 AWG
Yes
Yes
Figure 2
Figure 1
Figure 4
Figure 5
Figure 6
Figure 7
Figure 9
Figure 8
Installation
Instructions
PW167600AV
Figure 3
