FT-67 Anfora Fountain
Two people are recommended for the installation of this fountain!
Revised February 28, 2017
Assemble your fountain on a level surface capable of holding a minimum of 867 pounds with an approximate 11.5 square
foot footprint.
FT-67C (376 lbs)
51”L x 33.5”W x 9”H
FT-67B (30 lbs)
17.5”L x 13.5”W x 5”H
FT-67A (180 lbs)
31”L x 18.5”W x 22.5”H
1.
Place the basin (FT-67C) into position where the fountain
will be installed, ensuring that it is level.
2.
Assemble the pump kit
a.
Using a hose clamp, attach the 1/2” non-kink tubing
to the pump outlet.
b.
Place a hose clamp over the other end of the 1/2"
non-kink tubing
c.
Place the stopper around the pump cord
approximately 6” from the pump.
3.
Feed the pump cord through the hole in the basin (FT-67B)
and out the channel.
4.
FIRMLY
press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or hammer
works best to press the stopper in place.
5.
Place the pump cover (FT-67B) over the pump.
6.
Attached the 3/4" threaded end of the plastic adapter to the
threaded copper on the bottom of the urn (FT-67A).
7.
Carefully position the urn (FT-67A) over the pump cover
(FT-67B).
8.
Secure the loose end of the non-kink tubing to the barb end
of the plastic adapter with a hose clamp.
9.
Center the urn (FT-67A) over the pump cover (FT-67B).
10.
Insert the 21” copper pipe into the copper fitting inside the
urn (FT-67A).
11.
Fill the fountain with water.
